Every moisture problem has a different source. We identify yours specifically before we quote anything — then we deploy the right system, not the most expensive one.
💧
Interior Drain Tile & Perimeter Channel Systems
When hydrostatic pressure is the primary culprit, the most effective long-term solution is a properly engineered interior drainage system. We install sub-slab perforated drain tile around the perimeter of your basement — capturing water before it can rise above slab level — and route it to a sump pit equipped with a dual-pump configuration.
These systems don't fight hydrostatic pressure — they redirect it.
📞 Get a Free Drainage Quote →
🏗️
Exterior Foundation Coating & Drainage Board Installation
Exterior waterproofing is the most comprehensive solution available — stopping water before it contacts your foundation wall. We excavate to the footing, apply a rubberized polymer membrane to the exterior foundation face, install dimple-mat drainage board, and backfill with clean crushed stone to redirect surface water away from the structure.
We use SilkOate, UMARK, and other commercial-grade membrane systems — not the paint-on damp-proofing that deteriorates within a few years.
📞 Schedule an Exterior Assessment →
🔧
Foundation Crack Injection — Polyurethane & Epoxy Systems
We inject poured-wall cracks using a port-and-backer system: surface ports are installed at 8–12 inch intervals along the crack, the surface is sealed with hydraulic cement, and two-part polyurethane or epoxy is pumped under pressure from the lowest port up — filling the crack through its full depth.
Block wall repointing involves removing deteriorated mortar joints to a minimum depth of 3/4 inch and repacking with waterproof hydraulic mortar.
📞 Get a Crack Injection Estimate →
🌿
Full Crawl Space Waterproofing & Drainage Installation
Crawl spaces are the most overlooked moisture source in residential structures. An unencapsulated crawl space — even one that "never floods" — pumps humid air into your living area through the stack effect, raising indoor humidity, feeding mold growth in floor joists, and accelerating wood rot in your subfloor structure. Full encapsulation seals that air pathway permanently.
For crawl spaces with active water entry, we install a perimeter drain channel at the footer line, route it to an appropriate discharge point or sump.
📞 Schedule a Crawl Space Inspection →
⚙️
Primary & Backup Sump Pump Systems for Romney Homes
A sump pump is only as reliable as its installation and backup plan. We install primary pumps — typically 1/2 to 3/4 HP cast iron submersibles with a minimum 10-year rating — alongside battery-operated backup systems that activate automatically when your primary pump fails or power goes out.
For finished basements and properties with high groundwater, we recommend a dual-pump system: a primary submersible at normal operating level and a pedestal backup set two inches higher.
📞 Get a Sump System Quote →
🪟
Window Well Drainage & Egress Window Waterproofing
We excavate and regrade window wells to the proper dimension, install a gravel drain bed with a perforated pipe tied into your perimeter drainage system, and apply waterproof flashing around the window frame — stopping the entry point at the source instead of managing it inside.
Egress window installations create a significant opening in your foundation wall, and sealing the rough opening properly is as important as the window itself.
📞 Book a Window Well Assessment →
